Mazda RX8 to Honda K-series K24 K20 Engine Mount brackets

This listing is for a set of engine brackets that will aid you in bolting the Honda K-series engine into the Mazda RX8 Chassis. These engine Brackets were designed to use the (Collins adapters Honda K-Series K24 to Mazda RX8 Transmission adapter plate) in order to get the engine and transmission to bolt up in the correct spot. These engine brackets only work with the Collins adapter plate due to the thickness of the adapter. These engine brackets will shift the engine and transmission around a bit in the engine bay however the transmission will fit into its stock position (as far forward as possible) and will use the factory PPF brace and the factory carbon fiber driveshaft. What is included in the kit: Passenger side and driver's side Engine Brackets to bolt the engine into the Mazda RX8 chassis Fasteners to bolt the engine brackets to the engine. What is required: You will need to grind down a small hump on the upper oil pan, directly above where the oil bolt goes through the aluminum casting on the passenger side(USDM). You will need to use the Stock Mazda RX8 rubber engine Isolators You need to cut the front crossmember to get the stock oil pan to fit into the engine bay properly You need to Hammer the firewall heavily to get the engine far enough back in order to drop the engine and transmission into the chassis. There will be the wiper cowling that will hit the top of the engine as the engine is too tall, you will need to remove cut out the section of wiper cowling that interrupts the top of the valve cover. If you have any questions or want to check stock please call 803-792-7189